14. Case 08: The Pencil Holder of the Minions#

14.1. Introduction#

A pen holder is a columnar container for holding pens or other long stationery, and comes in a variety of shapes and materials. Traditional penholders are made of wood, stone, pottery, bamboo, and other materials.

../_images/tooca-laser-1-case-08-01.png

14.2. Materials used#

TOOCA laser 1

3mm Plywood

14.3. Relevant parameters#

Model TOOCA Laser 1
Material of consumables Basswood board
Thickness 2.8mm
Power 100%
Speed 240mm/min
Times required to be engraved/cut 3

Note: This case takes a 2.8mm basswood board as an example. If you need to use different thicknesses or use different materials, please modify the drawing by yourself and refer to the Recommended parameter modify the parameters of the software.

14.5. Effect Show#

../_images/tooca-laser-1-case-08-01.png

../_images/tooca-laser-1-case-08-02.png

../_images/tooca-laser-1-case-08-03.png

14.6. material data#

More detail about the material:laser cutting materialLaser engraving material

Welcome to join the Laser Engraving Cutter Creative Sharing Community to share your creativity.