9. Case 03: The Elk#

9.1. Introduction#

The elk is a large herbivore with a black longitudinal stripe on the back of the neck and a brownish-white belly and rump, and after September the body fur is replaced by a longer, thicker gray winter coat.

../_images/tooca-laser-1-case-03-01.png

9.2. Materials used#

TOOCA laser 1

3mm plywood

9.3. Relevant parameters#

Model TOOCA Laser 1
Material of consumables Basswood board
Thickness 2.8mm
Power 100%
Speed 240mm/min
Times required to be engraved/cut 3

Note: This case takes a 2.8mm basswood board as an example. If you need to use different thicknesses or use different materials, please modify the drawing by yourself and refer to the Recommended parameter modify the parameters of the software.

9.5. Effect show#

../_images/tooca-laser-1-case-03-01.png

9.6. material data#

More detail about the material:laser cutting materialLaser engraving material

Welcome to join the Laser Engraving Cutter Creative Sharing Community to share your creativity.